Pack of 5 back plates for dolls house wiring systems.
These back plates can be fitted directly to the base of dolls house light fittings. The light fittings can then be plugged into the dolls house circuit using hollow eyelet or grip contact sockets. Using this method it is easy to remove and replace the light fittings when necessary to change the bulb or replace the fitting without disturbing the dolls house wiring and decor.
Dimensions: 15mm diameter
Back Plate Fitting Instructions
Dolls house lights are generally supplied with a long length of wire with plug two pin attached and a self-adhesive pad on the base. Begin by removing the self-adhesive pad taking care not to damage the wire and then cut off the excess wire just leaving 2 - 3 inches attached to the light. Next pass the wire through the hole in the back plate and position it on the base of the light and glue in position using a general purpose adhesive suitable for metal / plastic. Next carefully separate the two wires, wind them once around the pins on the back plate then bare the ends of the wires and wrap one tightly around each pin to form a good connection. The light can now be plugged directly into the dolls house sockets and easily removed as required. See photo above.